Pick up the trolling motors on the bow of the boat. Release the latch on the bottom and ride the electric motor working with the help of his friend. It will be hard and I fall off the boat, so be very careful with this step.
Place the company in one place, lower and allows storage of the engine without touching the edge of the blade is. Carefully position to be mounted on the bow. A crayon or dry erase markers work well for them.
Remove the electric motor boat when the assembly is allowed.
Use the mounting template supplied with the new electric motor. When the engine is used, you must have a model or mounting a trolling motor back to the point marked on the sheet. In both methods, mark the hole locations on the sheet. Drill holes with a 1/2-inch drill.
Slide the T-bolt through the rubber isolators 1/2-inch rectangular holes in the head, resting on the top of the mouth.
Turn on the electric motor rubber bushings and insert and tighten the mounting screws provided.
Install the electric motor in the unit and tighten the screw.
Connect the pedal to the engine power output.
Adjust the depth of the electric motor is running when the boat is actually floating in the water. to allow the screw terminals in supporting the drive shaft, up or down. good depth is deeper in the range of 1 to 2 meters, but the shallow weed flat as required.
