1 Set the Transom Mount Trolling Motor clamp on the center of the transom. Tighten the mounting clamps loosely by hand. The control handle should face the bow of the boat; the propeller should face the rear. 2 Sit in the rear seat facing forward and with your hand on the control handle. Adjust the position of the Transom Mount Trolling Motor on the transom to the most comfortable operating position for you. Once this location is determined, tighten the transom clamps. It is important for these clamps to be very tight. 3 Set the deep cycle battery on the floor of the boat as far forward from the Transom Mount Trolling Motor as allowed by the length of the battery cables. Connect the cables to the battery by attaching the red spring clamp to the positive terminal and the black clamp to the negative terminal. 4 Place the boat in the water and sit in the seat. Adjust the depth of the Transom Mount Trolling Motor by adjusting the clamp on the shaft and allowing the motor to slide within the clamp until the motor is low enough to allow the propeller to be completely under water. 5 Turn the Transom Mount Trolling Motor from side to side with the hand control. Insure that the cables allow full side-to-side movement. If not, relocate the battery rearward to create additional slack in the cables until full turning is possible. Hand control and finite variable speed series Haibo brand electronic motor becomes the first option of people because of its advantage of stable function.easy operation and environmental protection. The various speed adjustment system of 5F&2R can meet with the demand of different users. Choose it,you can experience the peaceful mood. Characteristic 1.Various ranges from 18 pounds to 110 pounds thrust 2.It can satisfy the different demands with the multi-speed mode. 3.Quiet and stable. 4.available with telescopic hand. 5.High efficient motor with longer life and energy saving. 6.Portable,easy use and installation. The article comes from Transom Mount Trolling Motor.